Power controls (start, stop, restart)
May 3, 2026
From your service's detail page you can control the VM's power state with Start, Stop, and Restart. These actions are equivalent to powering the machine on, shutting it down, or rebooting it from the host.
Start
Use this when the VM is stopped. It powers the VM on. The VM will boot its operating system; after a short time (usually 30 seconds to a couple of minutes) it should be reachable via console or SSH. The button may be disabled when the VM is already running.
Stop
Use this to shut the VM down. The system will attempt a graceful shutdown (sending a shutdown signal to the OS) when possible, so that the OS can close files and shut down cleanly. In some cases the VM may be stopped forcefully if it doesn't respond. After stopping, the VM will no longer use resources and won't be accessible until you start it again. The Stop button is typically disabled when the VM is already stopped.
Restart
Use this to reboot the VM while it's running. The VM will go through a shutdown and then start again. Restart is useful after changing configuration or when the VM is unresponsive but still running. It may be disabled when the VM is stopped.
What to expect
After you click an action, the state may take a few seconds to update. The page might show Starting, Stopping, or Restarting briefly. Don't click the button repeatedly; one click is enough. If the state doesn't change or you see an error, wait a moment and refresh the page, or open a support ticket if the problem persists.
More in Services & VMs
Other articles you might find useful.
- Viewing your servicesFind VMs, containers, Quick Apps, and game servers.
- LXC containers versus virtual machinesWhat differs between QEMU VMs and LXCs.
- Using the VM consoleAccess your VM with the in-browser console.
- Finding credentials and IPsWhere to find login details and IP addresses for your service.
- Service suspended – what to doWhy a service might be suspended and how to restore it.